![]() ![]() Anything longer than that will fall into 4" or 6" Extension Tap. But if you need longer Reach then a DIN Tap is a little longer and will give you clearance in deeper holes, this is on page 2 of the pdf below. Most Taps will be ANSI, which is on page 1. If you also use a Synchro Tap Holder that gives better runout and Axial Compensation then you can run it much faster:īelow is a link to the standard tap dimensions all our ANSI and DIN Taps are manufactured to. You can run these in a standard holder and these will improve tap life. ![]() This is available in Spiral Flute and Spiral Point Cut Taps as well as Form Taps with more Lobes to reduce Tool Pressure.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |